Jazzy 1113 ATS
www.pridemobility.com
25
V . C O M F O R T A D J U S T M E N T S
COMFORT ADJUSTMENTS
After becoming familiar with your power chair’s operation, you may find the need to make some adjustments to increase
your comfort, such as seat height and angle, armrest angle, foot platform height and angle, and controller position. If your
power chair is equipped with a Synergy Seating System or Synergy TRU-Balance Power Positioning System, refer to the
information in separate manuals. If your power chair is equipped with a contour seating system, refer to the following
information.
WARNING! If your power chair was configured by your authorized Pride Provider, please consult your
healthcare professional before making any adjustment that may degrade your power chair’s
performance and safety by changing its center of gravity.
WARNING! Some power chair components are heavy. You may need assistance to lift or carry
them. Please refer to the specifications table for specific component weights before you
disassemble the power chair.
WARNING! Prevent injury. Remove the occupant from the power chair before making any adjustments.
You may need the following to make comfort adjustments:
!
metric/standard socket set and ratchet
!
adjustable wrench
!
metric/standard hex key set
!
thread lock
Seat Height and Seat Angle Adjustment
You can change the seat height by either raising or lowering the four seat towers.
To change the seat height:
1. Turn off the power to the controller.
2. Disconnect the controller harness connector from the electronics tray.
3. Remove the ball detent pins that attach the trapeze bars to the seat towers. See
figure 14.
4. Remove the seat.
5. Remove the battery harnesses.
6. Remove the battery boxes.
7. Remove the ball detent pin from each seat tower as shown in figure 21.
8. Raise or lower each seat tower to the desired position.
9. Install the ball detent pin into each seat tower.
10. Reinstall the battery boxes.
11. Reinstall the battery harnesses.
12. Reinstall the seat and secure the trapeze bars.
13. Connect the controller harness connector to the electronics tray
To change the seat angle:
Raise or lower only one set of seat towers (front or rear).
Figure 21. Seat Tower
BALL DETENT PIN
