Jazzy 1113 ATS
www.pridemobility.com
45
V I I . O P E R A T I O N
Battery Condition Meter
The battery condition meter consists of six lights arranged in an arc over the battery icon. From left to right, the first two are
red, the second two are orange, and the last two are green. These lights give you an accurate indication of your usable
battery capacity. If the battery has at least 85% of its rated capacity, all of the lights will be on. As the battery voltage
drops, the number of lights reduces from right to left. When the battery capacity drops to 10% or below, all of the lights will
flash once every second.
Drive Program Select Key
The drive program select key enables you to select a drive program and an actuator mode. Your Dynamic DX controller
was preprogrammed at the factory for five drive programs— 1 (slowest) to 5 (fastest). The drive mode is indicated by a
number in the center of the keypad.
NOTE: The drive mode settings are preset at the factory. If your authorized Pride Provider changes these
settings, please make note of these changes.
To change the drive mode program:
1. Press the drive mode select key.
2. Move the joystick right to increase the drive mode program.
3. Move the joystick left to decrease the drive mode program.
4. Press the drive mode select key.
Drive Mode and Actuator Display (also Remote Status Display)
This is a seven-segment light that displays the drive program. It also displays a drive inhibit and actuator mode (if applicable)
when they occur.
Actuator Select Keys with Lights
If your power chair is equipped with power accessories such as a power seat or power elevating leg rests, you can
operate them through the remote keypad. Contact your authorized Pride Provider for information on how to operate these
accessories.
Remote Status Light
This light will flash if there is an internal Dynamic DX Remote fault, or if an OONAPU fault has occurred. See “Out Of
Neutral At Power Up.”
Horn Key
The horn key activates the horn.
Battery Saver Feature
When the battery capacity drops to below 21V (typically two lights), the controller will reduce power chair performance
to conserve battery power.
Off-board Charger/Programming Socket
You may use an off-board charger to charge the power chair batteries through the 3-pin socket located on the front of the
Europa. See figure 36. If you use an off-board charger, the charger current should not exceed 8 amps. Contact your
authorized Pride Provider for more information.
