26
www.pridemobility.com
Jazzy 1113 ATS
V . C O M F O R T A D J U S T M E N T S
Seat Position
You can move the seat forward or rearward by changing the extru-
sion mounting position.
To change the position:
1. Turn off the power to the controller.
2. Disconnect the controller from the electronics tray.
3. Remove the seat from the power base.
4. Remove both extrusions from the bottom of the seat.
5. Reposition the extrusions on a different set of mounting holes.
You must move both extrusions the same number of holes either
forward or backward. See figure 22.
6. Fasten the extrusions back onto the bottom of the seat.
7. Reinstall the seat.
8. Connect the controller to the electronics tray.
Manual Recline Seatback Adjustment
If your power chair is equipped with an optional reclining seat, you
can adjust the seatback angle with the seatback release lever. The
lever is located on the right side of the seat base.
To adjust the seatback angle:
1. Pull up on the seatback release lever.
2. Move the seatback down or up to the desired position.
3. Release the lever.
Headrest Adjustment
If your power chair is equipped with the optional high-back seat
with headrest, you can adjust the headrest height.
To adjust the headrest height:
1. Push in the headrest release button.
2. Move the headrest up or down to the desired position.
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seatback, you
can adjust it to four (4) different angles: 90°, 102°, 105°, or 107°.
To adjust the seatback angle:
1. Remove the seatback angle adjustment screws from both seat
hinges. See figure 23.
2. Set the seatback at the desired angle.
3. Reinstall the screws to both seat hinges and tighten.
Armrest Width Adjustment
You can change each armrest’s width independently of the other.
Figure 23. Seatback and Armrest Adjustments
SEATBACK
ANGLE
ADJUSTMENT
SCREW
ARMREST KNOB
JAM NUT
ARMREST
ANGLE
ADJUSTMENT
SCREW
Figure 22. Seat Mounting Holes
ARMREST
HEIGHT
ADJUSTING
SETSCREWS
