22
www.pridemobility.com
Jazzy 1113 ATS
To disassemble your power chair:
1. Disconnect the controller harness from its connector on the
electronics tray. See figure 6. You may need to pull firmly and
gently wiggle the harness to remove it from the connector.
2. Remove the ball detent pin from each seat tower. See figure 14.
3. Pull up on the seat. You may find it necessary to wiggle the
frame gently from side to side to free it from the seat towers.
WARNING! Do not pick up the seat frame by the
armrests. They are free to pivot, and you may lose
control of the seat if they do so, resulting in
personal injury and/or damage to the chair.
4. Remove the foot platform by lifting it up, then pulling it out away
from the chair. See figure 15.
5. Disconnect both battery connectors and both motor connectors.
See figure 7.
6. Lift and remove each battery box. See figure 16.
7. Squeeze together the latch release levers that hang vertically
down from the crossbar at the rear of the battery well frame.
See figure 17.
8. Lift up the rear end of the battery well frame. Pull it to the rear
of the chair to release the front slots from the locating pins on
the front frame bottom bar.
9. Stand behind your power chair and grasp one of the power
base frame assembly handles. See figure 18.
10. Press the chrome latch release lever toward the center of the
frame and hold it.
11. Push the frame assembly outward and pull up on the front frame
until the latching mechanism releases.
12. Keep pulling upward until the locating pin on the bottom of the
front frame releases from its slot in the power base frame
assembly.
13. Carefully let the power base frame assembly tilt to a resting
position.
14. Repeat steps 9-13 for the other power base frame assembly.
I V . D I S A S S E M B L Y A N D A S S E M B L Y
Figure 16. Removing Battery Boxes
Figure 15. Foot Platform Removal
