PDW90 Point to Multi-Point Wireless Instruction Manual
33
Making Changes to a Password Protected Field Unit
Once a password has been set on the device, you will be required to enter that password before being
allowed to access the device menu.
Note: Setting a password will require you to enter the password to access the device settings via the PC
software as well.
Did you forget the password?
The password may be disabled by entering a master
password. If you are authorized to make changes, enter
the master password 7300 to unlock the device.
Restore Defaults
If a mistake has been made while programming the field unit and it is unclear where the error occurred,
the best option may be to perform a factory reset of the device and begin again.
Display Signal I/O and Digital I/O Status
Pressing either the
previous
or
display
buttons while the device is in run mode will cycle through the dis-
play modes. These modes are, in order,
link status
,
analog I/O
, and
digital I/O
.
LINK OK
PRI RSSI 10 RT
0000
ENTER PASSWORD
Run Mode
ACCESS GRANTED
increments selected digit.
selects next digit to the right.
TRY AGAIN
ENTER PASSWORD
1 Sec
If I
nc
orr
ec
t
DEFAULTS
RESTORE
NO
LOAD DEFAULTS?
YES
LOAD DEFAULTS?
Unit will load default
settings and reboot.
LINK OK
PRI RSSI 10 RT
AOUT: 20.00 mA
AIN: 20.00 mA
DO3:OFF DI4:OFF
DI1:ON DO2:ON
www.
.com
1.800.561.8187
