PDW90 Point to Multi-Point Wireless Instruction Manual
21
Input / Output Module Configuration
The
Base Station IO Configuration
tab is where individual I/O modules connected to the base station may
be programmed. Click on one of the installed modules in the
IO Modules
list to the left of the screen in
order to begin programming that module.
Analog Inputs Module
Each
Analog Inputs
module has two input channels. Each channel may be independently programmed to
accept either a 4-20 mA, 0-10 V, 0-5 V, or 1-5 V analog input. These channels may also be mapped to
remote analog outputs or Modbus registers. Once you have modified the module’s settings, click the
Save Module Configuration
button to save these settings to the base station.
If you have made changes to the module that have not been saved and would like to load the saved set-
tings from the base station, click the
Read Settings from Hardware
button. If you would like to reset the
selected module to its default settings, click the
Load Default Settings
button.
The Monitoring area at the bottom may be used to view the current analog input reading or manually test
analog input operation.
Note: For information about
Modbus Access
, please see
Modbus Register Address vs Modbus Register
Number
on page 28.
www.
.com
1.800.561.8187
