28
Figure 10.7
Figure 10.6
DC Voltage/Current Module
Relay/SSR Module
B
A
A
1
2
3
B
1
2
3
DC Linear Voltage / Current Module
The DC Linear Module is factory configured for either Current or Voltage output. The current output can be configured for 0-20
mA or 4-20 mA and similarly the voltage output can be configured for 0-5 V or 0-10 V through parameter settings.
MOUNTING / UN-MOUNTING OF MODULES
The Figures 10.8 & 10.9 illustrates how to mount the plug-in Output-2 & Output-3 module, respectively. Notice the orientation
of the controller and a few identifying components shown in figures to help locate the plugs for the modules. Ensure that the
socket snap-fits into the plug and the 2 projected parts on the module fit into the 2 slots provided on the Power-Supply / CPU
PCB for proper electrical contacts and secured fitting.
For plugging out the module(s), follow the steps below:
1. Gently pull apart the Power-supply board and the CPU board until the projections of the module board come out of the slots.
2. Pull the module outward to unlock the socket from the plug.
Table 10.2
Relay
SSR
Output Type
Jumper Setting - A
Jumper Setting - B
User Manual
neuro 102
OUTPUT-2 & OUTPUT-3 : Modules and Jumper Settings
The
Output-2
and
Output-3
Modules come in three versions, viz., Relay / SSR, DC Linear Voltage and DC Linear Current. The
two modules are identical and, thus, can be fitted interchangeably in Output-2 or Output-3 positions.
Relay / SSR Module
This module can be configured for either Relay or SSR output through proper jumper selection. Two jumper settings A and B,
as shown in Figure 10.6 and Table 10.2, are required for Relay or SSR selection.
