6
Table 2.2
PROFILE ABORT COMMAND
These parameters are mutually exclusive. Use start command to
commence a new Profile Cycle and Abort command to abort /
terminate a running Profile cycle. Set the value to ‘Yes’ to issue the
command.
PROFILE START COMMAND
These parameters are mutually exclusive. Use start command to
commence a new Profile Cycle and Abort command to abort /
terminate a running Profile cycle. Set the value to ‘Yes’ to issue the
command.
Parameter Description
Settings
(Default Value)
AUXILIARY SETPOINT
The alternate control setpoint that the controller respects for
control purpose when selected through remote input terminals.
This parameter is available only if the hardware
Remote Input
module is fitted and if the selected Utility Option is
Auxiliary
Setpoint.
No
Yes
(Default : No)
This is the Setpoint value that the controller respects for the
control purpose while it is not running a profile or not in standby /
tuning mode.
CONTROL SETPOINT
No
Yes
(Default : No)
No
Yes
(Default : No)
(Default : -200)
Setpoint Low Limit
to Setpoint High Limit
(Default : -200)
Setpoint Low Limit
to Setpoint High Limit
This parameter is available and applicable only if Standby mode is
enabled at supervisory level. Set the parameter value to ‘Yes’ or
‘No’ for entering and exiting the Standby mode, respectively.
STAND BY MODE
ALARM-1 WINDOW BAND
Same as Alarm-1 Setpoint
ALARM-1 DEVIATION BAND
Same as Alarm-1 Setpoint
ALARM-1 SETPOINT
The setpoint / Band value (depending upon the type of Alarm) for
Alarm-1. This parameter is not available if the selected Alarm type
is ‘None’.
Throughout the range for
the selected Input Type
(Default :
For Process Low :-200
For Process Low :1300)
(Default : 3)
-999 to 999
(Default : 3)
3 to 999
User Manual
neuro 102
