Powerten D3 Series, Operation Manual

Page: 18 / 65

2.3 LOCATION AND MOUNTING
The “P” Series models are intended for mounting in a standard 19.0-inch equipment
rack. Four screws, two on each side of the front panel, should be used to secure the
unit in place.
NOTICE
The unit should be provided with proper
ventilation. The top, rear and both sides of
the unit should be free of obstructions.
Follow the instructions in paragraphs 3-2
through 3-10 for setup and operation of the
equipment.
Table 2-1
2kW to 3kW High Series Input/Output Connectors
CONNECTOR FUNCTION CONNECTS TO
FL1 - AC
FL1 - AC
FL1 - AC
CHASSIS - GND
Pos. Bus Bar
Neg. Bus Bar
Pos. Threaded Stud
Neg. Threaded Stud
J1
Prime Power Input
(Std)
(with opt. 3 phase)
Output Power
<=60 volt models
(see Table 2-3)
>=80 volt models
(see Table 2-3)
Control Interface
190-253 VAC (Std)
47-63 Hz
Power Source
User
load(s)
See Table 3-1 for a
description
M550001-01
2-2