V4.0
16-Speed Floor Mount Drill Press
8708703
Visit www.princessauto.com for more information
5
5. Always use the correct drilling speeds for the drill size and the type of
material being drilled.
6. Never attempt to drill into a workpiece that does not have a flat surface
unless a suitable support is used.
7. Always stop the drill before removing workpieces, work supports or swarf
from the table.
8. Adjust the table or depth stop to avoid drilling into the table surface.
9. Always be sure that the drill bit is securely locked in the chuck.
10. Never assemble or set up any work on the table while the drill is running.
11. Always ensure the table lock is tight before starting the drill.
12. Keep handles dry, clean and free from oil and grease.
13. Do not depress the spindle lock when starting or during operation.
POWER TOOL PRECAUTIONS
1. Do not use a power tool with a broken or inoperative trigger/power switch.
2. Do not allow the tool to run without load for an extended period of time, as
this will shorten its life.
3. Do not cover the air vents. Proper cooling of the motor is necessary to
ensure normal life of the tool.
4. Avoid unintentional starting. Ensure the switch is off when connecting to
the power source.
5. Disconnect the power source before installing or servicing the tool.
6. After making adjustments, make sure that any adjustment devices are
securely tightened.
7. Remove adjusting keys and wrenches before turning the tool on. A wrench
or a key that is left attached to a rotating part of the tool increases the risk
of personal injury.
8. Never force the tool. Excessive pressure could break the tool, resulting in
damage to your workpiece or serious personal injury. If your tool runs
smoothly under no load, but does not run smoothly under load, then
excessive pressure is being used.
9. Do not touch an operating motor. Motors can operate at high temperatures
and can cause a burn injury.
