8708703
16-Speed Floor Mount Drill Press
V4.0
14
For technical questions call 1-800-665-8685
point on the end of the arbor locates correctly with the drive slot in the
spindle shaft.
5. Pull the spindle down using the feed handles, pressing the chuck nose hard
against a piece of scrap wood on the table, to press the chuck into place.
PULLEY COVER KNOB
Locate the Knob and Pan Head Screw and attach to the Pulley Cover. Screw
on tightly.
ADJUSTMENTS
The table is capable of moving in four directions.
1. Raise or lower the table by slackening off
the arm locking handle (Fig. 3-1) and
turning the crank (Fig. 3-6), clockwise to
raise and counterclockwise to lower.
2. Swivel the table about the column by
slackening off the arm locking handle. The
table assembly, arm and rack (Fig. 3-2),
move as one around the column.
3. Tilt the table by slackening the bevel table
locking screw (Fig. 3-5) and tilting to the
required angle.
A scale (Fig. 3-3) is provided on the arm
measured in degrees to assist in setting
the required angle. For all normal
operations the table should be set at 0°.
4. To ensure that the drill is entirely
perpendicular to the table, insert a piece
of straight round bar in the chuck, place a
square on the table and bring it up to the round bar. Adjust the table tilt if
necessary so that the table is correctly aligned.
5. Turn the table about its axis by slackening off the clamp (Fig. 3-4).
IMPORTANT! When the table is angled/tilted, ensure the workpiece is
clamped to the table.
Fig. 3
