Poweramp RCR Series, Owner & User Manual

Page: 14 / 60

12
4111-0044 — June 2021
© 2021 Systems, LLC
Installation Precautions
INSTALLATION
Installation of RCR dock levelers from inside is
recommended, as combined height of leveler
and proper lifting equipment may be greater than
outside door height.
File Name: 1751-0138 Rev B
Decal Size: 4 x 2
CRUSH HAZARD
DO NOT REMOVE hydraulic cylinder until leveler is
safely supported by maintenance prop. Refer to
owner’s/user’s manual for proper maintenance
procedure. Failure to comply will result in death or
serious injury.
1751-0138 Rev B
DO NOT grind or weld if hydraulic fluid or other
flammable liquid is present on the surface to be
ground or welded.
DO NOT grind or weld if uncontained hydraulic fluid
or other flammable liquid is present. Stray sparks
can ignite spills or leaks near the work area. Always
clean up the oil leaks and spills before proceeding
with grinding or welding.
Always keep a fire extinguisher of the proper type
nearby when grinding or welding.
Only trained installation professionals with the
proper equipment should install this product.
It is recommended and good safety practice to use
an additional means to support the dock platform
and lip anytime when physically working in front of
or under the dock leveler. This additional means
may include, but is not limited to a boom truck, fork
truck, stabilizing bar or equivalent.
Always post safety warnings and barricade the
work area at dock level and ground level to prevent
unauthorized use of the dock leveler before
installation is complete.
A hard hat or other applicable head protection
should always be worn when working under or
around a dock leveler.
Always stand clear of platform lip when working in
front of the dock leveler.
DO NOT connect the vehicle restraint electrical
wiring and ground connections until all welding has
been completed.
DO NOT ground welding equipment to any hydraulic
or electrical components of the vehicle restraint.
Always ground welding equipment to the vehicle
restraint base, NEVER to the moving components.
Failure to follow these instructions may damage the
motor, hydraulics, wiring, and/or control panel.
Stored
Position
Maintenance
Position
Pin
Maintenance
Prop
Decal Size: 4 x 6.25
File Name: 1751-0555 Rev F
CRUSH HAZARD
DO NOT WORK UNDER OR IN FRONT OF
RAIL RAMP
unless ALL props have been properly
positioned and secured. First, pull pin to position side
maintenance prop(s) as shown below. Failure to do
so will result in death or serious injury. Refer to
owner’s/user’s manual for proper procedure.
1751-0555 Rev F