Maintenance
Mains plug replacement
If the moulded 3-pin plug attached to the unit is damaged and needs
replacing, it is important that it is correctly destroyed and replaced by an
approved BS 1363 fused plug and that the following wiring instructions are
followed.
The wires in the mains cable are coloured in accordance with the following
code:
blue neutral
brown live
As the colours of the wires in the mains cable of the unit may not correspond
to the coloured markings identifying the terminals in the plug, proceed as
follows:
- The wire which is coloured blue must be connected to the terminal which is
marked with the letter N or coloured black.
- The wire which is coloured brown must be connected to the terminal which
is marked with the letter L or coloured red.
Make sure that the machine is not live when carrying out
maintenance work on the motor.
These machines have been designed to operate over a long period of time
with a minimum of maintenance. Continuous satisfactory operation depends
upon proper machine care and regular cleaning.
Cleaning
Clean the housing regularly with a soft cloth, preferably every time it is used.
Keep the ventilating apertures free from dust and dirt. Remove stubborn dirt
with a soft rag moistened in soapy water. Do not use any solvents such as
petrol, alcohol, ammonia, etc. as such substances can damage the plastic
parts.
Lubrication
These machines don’t need any extra lubrication.
Faults
Should a fault occur, e.g. after wear of a part, please contact the service
address on the warranty card.
UK Helpline 0203-5142281 • Ireland Helpline 1800-719901
Web Support: www.servotool.eu
Model Number: PAC-18/4K
28
CDM6180 Ma-GB-IRE 1108-10.indd 28
8/10/11 10:32:35 AM
