Drill operation
UK Helpline 0203-5142281 • Ireland Helpline 1800-719901
Web Support: www.servotool.eu
Model Number: PAC-18/4K
16
Fitting and removing drill bits
In addition to drill bits, the tool can also accommodate screwdriver bits with
a hexagonal shaft.
• Loosen the drill chuck (3) by rotating the hand-grip.
• Insert the shaft of the drill bit into the chuck.
• Tighten the drill chuck so that the drill bit is firmly clamped.
• Rotate the drill chuck in the opposite direction when you wish to change
the bit.
Operation
Hold the appliance firmly and press the drill bit steadily onto the workpiece.
Do not overload the appliance.Only use drill bits with no visible wear. Worn
drill bits will have a bad effect on the functioning of the appliance.
Adjusting the torque
The appliance has 16 different torque settings with which to set the power
for driving and removing screws.
• Set the torque adjustment ring (2) to the desired position. The available
torque settings are indicated on the adjustment ring by the numbers 1 to
8 and by dots between the figures to define intermediate settings (16 in
total).
• You should preferably choose as low a setting as possible when using the
screwdriver. Select a higher setting if the motor slips.
Driving and removing screws
• Set the direction reversing switch (5) to position ‘R’ in order to drive screws.
• Set the direction reversing switch to position ‘L’ in order to remove screws.
Drilling
• Rotate the torque adjustment ring (2) to the drilling position.
Ensure that the direction reversing switch (5) is always set to ‘R’
during drilling.
CDM6180 Ma-GB-IRE 1108-10.indd 16
8/10/11 10:32:34 AM
