- 0 -
0700_GB-EIGEnVERSoRGUnG_1602
GB
MainTenance
Attention!
Run the drive only
with full enclosed
protection
Internal hydraulic supply for cross conveyor belt
For tractors without LS-hydraulics, unloading using the cross conveyor belt is not possible without an
internal supply (parallel operation necessary)
In this case an internal hydraulic supply can be fitted to the wagon for the cross conveyor belt.
Oil tank
Oil:
Hydraulic oil (See page “Fuels”)
Quantity:
50 litres
(Level approx. 50 mm below top of tank)
- Change hydraulic oil as per tractor manual
Change filter
Change runback filter (RF) at regular intervals
Pump
The pump is located under the right side guard
Attention!
Switch p.t.o. off and uncouple cardan shaft
from tractor
Change V-belts
- Uncouple cardan shaft (GW)
- Loosen straining screw (SP)
- Retensioning the V-belts take place with the straining
screw (SP) after loosening the lock nut.
- Retighten lock nut after tensioning the V-belts
Correct belt tension
When tensioned the belts for cross conveyor operation
must enable a -5 mm inward play
- 5 mm
Take note!
When unloading
using the cross
conveyor belt
the cardan shaft
should be opera-
ting at 1000 r.p.m
