- 11 -
0600-GB EINSATZ_3904
GB
OPERATION
1. Horizontally set lifting gear‘s lower link (15)
2. Adjust cutting height by turning upper link
spindle (16)
- cutter disc inclination: max. 5°
3. Set height of lifting gear (H1)
This lifting gear position (H1) does not need to be
changed when mowing or turning.
Using the tractor‘s lifting gear, raise or lower the
implement until a gap of about (H1 = 0) is achieved.
Adjusting the floor bearing load of the mowing bar
H1 = 0 Carry out basic setting
H1 + Decrease bearing pressure
H1 – Increase bearing pressure
Safety hints:
• Never
let
the mowing
mechanism run
with the mower
raised.
• Before you leave
the tractor, lower
the machine on to
ground!
- The mower unit is suitable for gradients of between
+22° and -30°.
4. Before mowing, throw-in p.t.o. slowly outside
crop and bring mower drums up to full
speed.
Noises conditional to p.t.o. free-wheel system can
be prevented through an even continious increase in
r.p.m.
- Travelling speed is set according to ground conditions
and crop.
5. Hydraulic control valve (ST)
• Single action hydraulic control valve (ST) to
“LOWER”
• Double-action hydraulic control valve (ST) to “FLOAT
POSITION”
Turning manoeuvre when mowing
The cutter bars can be raised hydraulically (22°)
- The drive must not be turned off to do this.
- The lifting gear‘s (H1) position does not need to be
altered when turning.
TD 79/98/01
15
122-02-17
16
General Guidelines when Working with Implement
Mowing
Attention!
Danger - flying objects; keep safe distance from
the machine as long as the engine is running.
bsb 447 410
Attention!
Do not enter the
mower unit area
as long as the
drive is running.
