0601-GB WARTUNG_3904
GB
- 20 -
MAINTENANCE AND SERVICE
V-belt Drive
- check V-belt tension
after 1 hour, after 5 hours, after 20 hours, then as
necessary
Setting range:
1 - 3 mm
• Retensioning is only necessary when the setting
becomes more than 3 mm.
• If one of the 3 V-belts is damaged or stretched, then
all 3 V-belts should be exchanged
IMPORTANT!
If the V-belts are tensioned too taut, the danger exists
of the bearing and shafts becoming damaged.
Number of fitted V-belts
NOVADISC 730
NOVADISC 900
272-06-11
Setting Relieving Spring
NOVADISC 730 " X " = 120 mm
Setting Relieving Spring
In order to prevent turf damage the cutter bar
- must be in an almost parallel position before being set
down
- must be set down with the outer end first
- and then the inner side
This is done by adjusting the short relieving spring (MASS
”X”)
If the inner side of cutter bar is to be set down first, increase
the tension of the relieving spring. (MASS ”X” lower)
