- 6 -
0600-GB ANBAU_3904
GB
ATTACHING IMPLEMENT TO TRACTOR
Set upper link spindle
- By turning upper link spindle (16) cutter is brought into
a horizontal or a slightly forward inclined position.
- By turning upper link spindle (16) the cutting height is
adjusted.
Fitting drive shaft
- Before operating for the first time, drive shaft is to be
checked and adapted if necessary. See alse chapter
‚Drive Shaft‘ in supplement B.
Connect hydraulic snap-connector (60)
Establish power supply
- Couple power supply cable to tractor (E3)
Run stop-lock support release
rope (S) into tractor cabin.
Safety hints:
see supplement-A1
Pkt. 8a. - h.)
Attaching implement to tractor
- Before
operating
for the first time,
drive shaft is
to be checked
and adapted if
necessary.
See alse chapter
‚Drive Shaft‘ in
supplement B.
1)
Wunschausrüstung
Centre-mount (M) mower unit to tractor
- Adjust lower link accordingly.
- Secure the lower hydraulic link so that the appliance
cannot swing sideways.
Horizontally set lifting gear‘s lower link
- Bring frame into horizontal position by adjusting linkage
arm spindle (15).
Setting lower link height
- Adjust tractor‘s hydraulics (ST) using bottom stop.
- The gap between lower linkage bolts and ground should
be approx. 650 mm
TD 79/98/01
15
