Part 13
Connect the cables to appropriate external devices through the cable
exit at the bottom of stand assembly. Please make sure that each connector has
to be connected to the right device in the right way.
CAUTION: On doing any insertion or extraction of any connector, please
always hold the connector head itself instead of pulling on the
cable wire. Failure to do this could damage the cable and jack
that is considered as an artificial destruction and is not
covered by the warranty.
DESKTOP MOUNTING
KS6115:258~355
Match the matching pegs on the back of the main unit against the
matching holes on the base stand assembly. First aim the matching pegs
toward the upper round part of the hole and make sure that all pegs are inside
the holes. Then slide the main unit down to move the pegs into the lower slot
part of the holes till it clicks. Note that all the cables come out of the stand
from the lower edge and won’ t get trapped by this mounting operation. If later
on you want to remove the main unit from the stand, you’ ll have to press down
the lock/release button on back of the stand at the time lifting the main unit.
For desk top/counter application, the total dimension of KS-6815
occupies a space of 378 mm wide, 313 to 316 mm deep and 268 to 362 mm
high per main unit tilt angle.
WALL MOUNTING
The wall mount model is delivered without any base but with a wall
mount kit. Please follow the installation guide that comes with the wall mount
bracket to fix the wall mount bracket on wall and then hang the main unit with
the matching pegs into the matching holes on wall mount bracket.
Please note that since there is no base for the wall mount model there
can be no base installed device nor base mount kit. The area required for wall
mount application is determined by the main unit dimensions and is 378 mm in
width and 312 mm in height.
Matching Holes
Matching Pegs
Round Part
Slot Part
