Part 10
12” 2
nd
LCD Panel Or Customer Display
Fit the joint base of PD-306
or PD-2501 or PD-2602 or LM-6101
to the rear connect cover opening.
Please route the interface cable
through the normal cable exit (under
the joint base) as in the 2 pictures. Fit
2 screws
through washers
at the arrowed screw holes to hold the joint tight.
For low profile customer display PD-305, the installation procedure is same.
Remember to enable the +5 V DC supply in the COM port of the main unit for
PD-2501, PD-2602 or PD-305 or PD-306 or the +12 V DC in VGA port for
LM-6101. The power supply in the I/O port must be disabled if it is no longer
required to support these intended devices otherwise
any damage or loss
caused consequently shall be out of product warranty!
However, if the
customer display used is the USB interface model, the DC supply in COM port
is not required, it will be powered through the USB port. Fit the interface cable
into the base mount device cable groove under bottom plate.
ROUTING THE CABLES THROUGH BASE
Place all the cables required for connections to the
main unit except those for the integrated attachment
through the front part inside the base stand assembly. Be
sure not to damage any cable during this operation.
Now, turn the adjustable base stand assembly back to normal
orientation and arrange all cables to come out of the area for mounting main
unit from the bottom edge for ease of later operation.
FRONT COVER OF GEN 5 BASE
Please note that the front cover on Gen 5 base
is designed for easy maintenance of the option HDD in
base and is not for end user application.
Please leave it
closed.
PREPARING THE MAIN UNIT
On the back of the main unit, there is a service window among the 4
matching pegs marked in square below. Remove the service window lock
screw to find several jumpers. The jumpers in this window are designated for
hardware reset functions and a reserved LPT port. Please consult your dealer
Route Cables through Front Part
Connect this End to Main Unit
