Part 11
for technical support on setup of these jumpers. Please note that only those
qualified technicians may adjust in the service window with information from
Posiflex and the contents in the service window may change without notice as
time develops. The option LPT conversion cable should be applied to the
connector as marked in an ellipse in left picture below. Route the conversion
cable from bottom side of the service window plate to connect the usual cable
for parallel device.
Please note the 2 crosses on upper right of the back cover that
indicates the 2 screws holding the cover of HDD cavity where the DDR2
SODIMM and the default SATA HDD or the option SSD or option CF card
reader are sited. Please leave them alone since they are only for qualified
service person to handle.
SIDE MOUNT UPGRADE KIT
Remove the 2 circled screws in last picture above
to remove the cover for side mount upgrade kit. Take out
the cable inside this cover as circled in right picture and
connect it to connector inside the side mount upgrade kit
like SD400Z as arrowed in same picture. Gently arrange
the excessive length of this cable back in the hole and
screw-fit it back to the position originally occupied by the
cover. Please reserve the cover if there is chance to have the side mount kit
removed in the future.
REAR TOP MOUNT UPGRADE KIT
Please apply carefully the 2 small
fixation shoulder screws that come along with
PD-310 or PD-2604 to the back of KS-6815 at
the screw hole triangle marked in the 2 upper
right pictures. However please do not screw
them to the bottom but at a position that is
about 1 turn loose from the bottom. Similarly
please loosen the screws by 1 turn for some
KS models with these 2 screws preinstalled. Hook the rear bracket of the
upgrade kit onto the shoulder screws with the large circular holes. Slide to the
Service Window
Lock Screw
Jumpers
