System Installation
ROBO-8771VG2 User’s Manual
3-1
Chapter 3
System Installation
This chapter provides you with instructions to set up your system. The additional
information is enclosed to help you set up onboard PCI device and handle WDT
operation in software programming.
3.1 Onboard
Intel
®
Celeron M Processor
ROBO-8771VG2 contributes a low power consumption processor, which is based on
Intel Celeron M processor with 852GM north bridge and ICH4 south bridge.
3.2 Main
Memory
ROBO-8771VG2 provides one DDR-SODIMM socket of memory interface. The
maximum memory size can be up to 2GB, memory frequency includes 200/266.
Auto detects memory clock, which is according to BIOS CMOS settings.
For system compatibility and stability, do not use memory module without brand.
Memory configuration can be either one double-sided DIMM in either one DIMM
socket or two single-sided DIMM in both sockets.
Watch out the contact and lock integrity of memory module with socket, it will
impact on the system reliability. Follow normal procedures to install memory
module into memory socket. Before locking, make sure that all modules have been
fully inserted into the card slots.
3.3
Installing the Single Board Computer
To install your ROBO-8771VG2 into standard chassis or proprietary environment,
please perform the following:
Step 1 : Check all jumpers setting on proper position
Step 2 : Install and configure CPU and memory module on right position
Step 3 : Place ROBO-8771VG2 into the dedicated position in the system
Step 4 : Attach cables to existing peripheral devices and secure it
WARNING
Please ensure that SBC is properly inserted and fixed by mechanism. Otherwise, the
system might be unstable or do not work due to bad contact of PICMG 1.0 PCI plus
ISA-bus slot.
