System Installation
PEB-2530VL User’s Manual
3-2
z
Ethernet
: This driver supports Windows-4.0, Windows-9X.
Note:
For more detailed installation steps, please refer to our installation guide file.
3.3 IDE
interface
A primary as well as a secondary IDE controller is provided by the CS5530A
companion chip which supports Ultra DMA mode and PCI bus mastering for the
data transfer.
A standard IDC 44-pin connector and a Compact Flash type II connector on the
solder side of this board provide access to these controllers.
3.4 PCI
bus
The PCI-bus on the board is provided by the GX1 CPU and will always run at
33MHz.
The GX1 CPU provides support for up to three bus masters. The CS5530A and one
Intel 82559 Ethernet controller use these bus-master signals.
3.5 SDRAM
interface
This board uses 144-pin SODIMM. 3.3V PC 100 SDRAM modules are recommended
to use.
3.6 USB
The USB interface provides two USB channels that are controlled by the CS5530A.
The signals are provided by means of downlink 2 connectors.
