System Installation
PEB-2530VL User’s Manual
3-1
Chapter 3
System Installation
This chapter provides you with instructions on how to set up your computer system
using PEB-2530VL Embedded System Board. The additional information shows you
how to install Ethernet, Graphic in Operating System.
3.1
NS Geode GX1 XpressGRAPHICS Graphics Controler
The on chip XPRESS Graphics is based on the GX1 CPU and the CS5530A
Companion chip and this graphics controller is very cost efficient since almost no
additional components are required. This is achieved by using the SDRAM as frame-
buffer and by integrating the graphics engine and display interface in the GX1 CPU
and the CS5530A companion chip. This controller provides a CRT:
Driver Support
PEB-2530VL provides one CD-Title to support on-board VGA device drivers in
various operating systems. Before installing the device driver, please see the
reference files in each sub-directory.
If you have problems to install drivers directly
from CDROM, please copy the files into your hard drive before you proceed with
the driver installation.
z
VGA
: This driver supports Windows-4.0, Windows-9X.
Note:
For more detailed installation steps, please refer to our installation guide file.
3.2
On Board Fast Ethernet Controller
The Ethernet interfaces are based on one Intel 82559 Ethernet controller, which
support both 100Mbit as well as l0Mbit Base-T interface.
The Ethernet controllers are attached to the PCI bus and use PCI bus mastering for
data transfer. The CPU is thereby not loaded during the actual data transfer.
Driver Support
PEB-2530VL provides one CD-Title to support on-board Ethernet device drivers in
various operating systems. Before installing the device driver, please see the
reference files in each sub-directory.
If you have problems to install drivers directly
from CDROM, please copy the files into your hard drive before you proceed with
the driver installation.
