HYDRAULIC POWER UNIT G-18S10-54-W
OPERATION MANUAL
17
4.2.2
Fuel and oil
Use only gasoline with an octane rating of at least 87, an ethanol percentage of up to 10 % is permissible.
Selection of the correct oil must be carried out according to the conditions on-site: oils in the following table may be used.
Temperature range
Oil
5 °C / 41° F and higher
SAE 30
4 °C / 39° F and lower
5W-30
-18°C to 38 °C / -0.4° F to 100° F
10W-30
38 °C / 100° F and lower
5W-30 (synthetic)
Table 5: Types of oil
4.2.3
Supply, interfaces and connections
The machine is used to power hydraulic tools. Quick couplings are available for connecting the tools (3/8 " flat face).
Filling with fuel for the combustion engine and with hydraulic fluid is carried out on the control panel of the Hydraulic Power Unit.
Oil filling for the combustion engine is carried out on the engine itself.
The quick couplings and filling openings are shown in chapter design.
4.3
Function
Hydraulic energy for operating hydraulic tools is provided by PortaCo Inc.´s Hydraulic Power Unit. The hydraulic unit supplies a flow
of 40 lpm / 10 gpm at 140 bar / 2,000 psi. The pressure in the system is limited to max. 150 bar / 2,150 psi.
4.4
Boundaries and interfaces
The Hydraulic Power Unit consists of the parts shown in the chapter design. The battery limit is the connection to the hydraulic
tools. Fuel and auxiliary materials are not included in PortaCo Inc.´s scope of service. Other parts which are not directly part of the
machine are also excluded.