HYDRAULIC POWER UNIT G-18S10-54-W
OPERATION MANUAL
20
6.2.1
Start-up
1.
Clean the quick couplings.
2.
Connect the hydraulic hoses
Ensure that the hydraulic hoses are connected to the tool.
Ensure that the flow and return flow of the hydraulic unit are connected to the proper quick coupling.
Figure 4 & 5: Connecting the hydraulic hoses
3.
Set the flow regulator for the hydraulic fluid to the "OFF" position
4.
Push the gas lever towards "fast"
5.
Push the choke to "on"
6.
Turn the ignition until the engine starts.
7.
Slowly return the choke to "off" so that the engine continues to run and wait approximately 3 to 5 minutes.
8.
Set the gas lever all the way to "fast".
9.
Turn the flow regulator for the hydraulic fluid to the "on" position.
If the temperature of the hydraulic fluid is below 10 °C / 50° F, then let the hydraulic unit idle to warm up.
Operation of the tools is carried out directly on the tool.
6.2.2
Shutdown
1.
Set the flow regulator for the hydraulic fluid to the "OFF" position
2.
Set the gas lever to "slow" until the engine idles and wait 2 to 3 minutes.
3.
Turn the ignition to stop the engine.
4.
Disconnect the hydraulic hoses from the Hydraulic Power Unit. Then the hydraulic hoses can be detached from the tool.
Allow the hydraulic unit to cool down before transport.
In case of emergency, the hydraulic unit can be stopped by turning the ignition without following the procedure described.
