Porsche 9Y0.971.675.BE, Driver Manual, Page: 55 / 1111

53
In order to satisfy the requirements regarding the
limits on exposure to electromagnetic radiation
(1999/519/EC), install the charger so that there is a
minimum distance from all persons of 20 cm.
Observe the following instructions and recommenda-
tions in order to guarantee uninterrupted charging
with the charger:
– When installing a new electrical socket, select
an industrial electrical outlet with the highest
possible power available (adapted to the domes-
tic electric installation) and have it put into op-
eration by a qualified electrician. Porsche recom-
mends that you use a certified Porsche service
partner.
–
Where technically possible and legally permissi-
ble, the electric installation must be dimensioned
in such a way that the maximum nominal power
of the electrical socket used is available for
charging the vehicle.
–
Before installation, check that the necessary
power for charging a vehicle can be continuously
provided with the currently available domestic
installation. If necessary, protect the domestic
installation with an energy management system.
– The charger should preferably be operated in
earthed mains supply systems. The protective
conductor must be properly installed.
– If you are unsure about the electrical domestic
installation, contact a qualified electrician. Por-
sche recommends that you use a certified Por-
sche service partner.
–
If you intend to use the charger with a photovol-
taic system, contact a Porsche partner.
– In order to make full use of the charger and to
ensure fast vehicle charging, use either NEMA
electrical sockets with the highest possible cur-
rent rating appropriate for the power plug or in-
dustrial electrical outlets to IEC 60309.
–
When charging the high-voltage battery via the
household/industrial electrical outlet, the elec-
trical installation may be loaded to its maximum
capacity. Porsche recommends that you have
electrical installations used for charging checked
regularly by a qualified electrician. Ask a qualified
electrician which inspection intervals are appro-
priate for your installation. Porsche recommends
that you use a certified Porsche service partner.
–
On delivery, the charging current is automatically
limited to prevent overheating of the electrical
installation. Have a qualified electrician bring the
charger into operation and set the charging cur-
rent limit as required for the domestic installa-
tion.
g
Refer to chapter "Charging current limiting" on
page 71.
Proper use
Charger with integrated control and protection for
mode 2 charging, for charging vehicles with high-
voltage batteries that meet the generally applicable
standards and directives for electric vehicles.
e Always use the appropriate device version for the
local mains supply.
g Refer to chapter "Technical Data" on page 85.
The charger may only be used as a combined unit
consisting of supply cables, control unit and vehicle
cable.