FS3-3 Assembly July 2016
Page 9 of 16
On the inside of the unit, pull the tank forward in the
opening of the fl oor. Locate the dimples in the lower
portion of the rear and left wall panels. Drill four 13/64”
holes through the dimples and into the back of the tank.
Rivet from outside the restroom using (4) PC-000103
rivets with (4) PC-000106 back-up washers on the inside
of the tank.
Step 8: Tank Installation
PC-000103 Rivet
(4) Used in this step
PC-000106 Washer
(4) Used in this step
Step 9: Sink Installation
With someone on the inside holding the sink tightly in
the corner, locate the dimples on the outside of the unit.
They will be found on the middle portion of the rear and
the right wall panels. Using a drill with a 13/64” drill bit,
drill two holes through the side/rear and into the sink.
Open up the sink. To do this, insert a long thin object
(the key for the lock on the T.P. Dispenser works well)
into
the 1/4” hole directly below the bottom of the sink lid,
and while pushing down on the front of the lid of the
sink, push the
(key)
in to release the catch, and lift up
the lid. From the outside of the unit, rivet in place using
(2) PC-000103 rivets with (2) PC-000106 washers on
the inside of the sink. Fasten the bottom of the sink in
by driving a PC-000158 screw through the hole in the
aluminum foot pump plate and into the fl oor plate of
the base.
PC-000158 Screw
(1) Used in this step
PC-000106 Washer
(2) Used in this step
PC-000103 Rivet
(2) Used in this step
INSERT KEY
