FS3-3 Assembly July 2016
Page 12 of 16
Snap the Unisex Indicator Plate into the back of the Door Trim Panel. Place the Door
Trim Panel into the recess in the front of the door. While holding the Door Trim
Panel in position, place the Slide Latch
and Slide Latch Cover Plate on the inside
of the door and line up the holes of the Slide Latch Cover Plate, the Door, and the
Door Trim Panel.
Insert (4) PC-000158 screws and tighten.
NOTE:
These screws
should be tightened to the point where they will interfere with the sliding action
of the Slide Latch and then backed off slightly, leaving enough friction to prevent
the Slide Latch from sliding into the “In-Use/Open” position when the door shuts. The
U Shaped handle prevents persons from inadvertently moving the
slide latch to the “In-Use” position when exiting the
restroom.
Insert the fl ip “Male-Female” Indicator
Plate into the slot on the top edge of the Door
Trim Panel (
above where the Unisex Indicator Plate
is located).
Insert (2) PC-000147 screws into the
holes toward the hinged side of the door, line up
with the holes in the Door Trim Panel, and tighten.
If the optional lock is installed, unlock the lock by
inserting the key into the lock and turning to the
left and back to the upright position which is the
neutral or normal use position and remove the
key
(this allows the Slide Latch to move into the
“Open/In-Use” position when persons are inside
the restroom). Turn the key to the right and remove
the key for the locked position. Turning the key to
the left indicates the open position and the key can
not be removed until either in the “Open/In-Use”
or “Locked” positon.
IMPORTANT
:
The punched
1/4” hole in the center of the Slide Latch where
the “In-Use/Open” stamp is imprinted complies
with code enabling the door to be unlocked from
outside the restroom in the event of distress
and a person inside were unable to unlock the
door. A POINTED OBJECT INSERTED INTO THE
HOLE AND MOVING THE SLIDE LATCH TO THE
LEFT WILL ALLOW THE DOOR TO BE OPENED
PROVIDING THE DOOR HAS NOT BEEN LOCKED
WITH THE KEY.
Step 15: Door Panel /Slide Latch Installation
Step 16: Mirror Installation
Peel the protective cover from the front of the mirror. Place the mirror in
the recess in the door, and fasten in place using the plastic push-in fasteners
provided.
PC-000367 - Push-In Fastener
(4) Used in this step
Step 17: Toilet Seat Installation
Place the toilet seat on the top of the tank. Line up the holes in the hinge of the seat with the holes in the top of the tank.
Insert the seat bolts through the hinges of the seat and through the seat base. Lift open the seat base, thread the plastic
seat nuts on the ends of the bolts and tighten.
PC-000158 Screw
(4) Used in this step
PC-000147 Screw
(2) Used in this step
