FS3-3 Assembly July 2016
Page 10 of 16
Step 10: Screen Installation
Take a SG1-0035 large fl y screen and place the bottom
curved fl anges onto the top of the right side panel
(as
shown on the right).
Tilt the top of the fl y screen up into
place. Using the hole in the bottom, middle fl ange as a
guide, drill a 13/64” hole through the side panel. Rivet
in place using a PC-000102 rivet from the inside with
a PC-000106 back-up washer on the outside. Repeat
this step with the left side.
PC-000102 Rivet
(2) Used in this step
PC-000106 Washer
(2) Used in this step
PC-000106 Washer
(4) Used in this step
PC-000100 Rivet
(4) Used in this step
PC-000121 Washer
(4) Used in this step
PC-000104 Rivet
(12) Used in this step
Step 11: Roof Installation
Place the FS1-0061 top extrusion on the top edge of
the rear panel so that the miters line up with the left
and right extrusions, and that the grooved surface is
facing the outside. Place the roof on the top of the
unit with the arch in the roof going into the groove in
the top of the jamb. Put the rear edge of the roof in
the groove in the top rear extrusion. With someone
pushing down on the back of the roof, use the holes
in the rear extrusion as a drill guide, drill fi ve 13/64”
holes into the roof.
MAKE SURE TO ONLY DRILL
THROUGH THE ROOF AND NOT THROUGH THE
BACK OF THE TOP REAR EXTRUSION
. Rivet the
top holes in both the left and right rear extrusions as
well as the fi ve holes of the top rear extrusion using
(7) PC-000104 rivets. Push down on the front of the
roof while using the holes in the jamb as a drill guide,
drill fi ve 13/64” holes through the roof. Rivet in place
using (5) PC-000104 rivets. Locate the holes in the
top of each of the side panels. Push out on the top
of the side panel, and using a 13/64” drill bit, drill a
hole through the hole in the top of the side, and through the roof. Rivet in place using a PC-000100 rivet on the inside
with a PC-000121 washer and a PC-000106 back-up washer on the topside of the roof. Repeat for remaining three holes.
