26
5. Install the film pack simulator into the camera again. The camera should go through a
dark slide cycle with the following events happening:
•
The strobe should not fire.
•
The camera shutter blades should remain closed.
•
The strobe charging light (red) should come on and then go off.
•
The strobe ready light (green) should come on. (The green ready light will stay on
for approximately 30 seconds and will then extinguish if the camera is not used.)
•
The LCD control panel should appear as shown in Figure 3-3.
Figure 3-3. LCD control panel at completion of dark slide
6. Aim the camera at an object less than one foot (.1 meter) away and press the
S1/S10 button halfway down (preview mode). The following should happen:
•
A warning tone (beep! beep!) will sound.
•
A flashing yellow triangle within a yellow square will be visible in the viewfinder.
•
A red figure “1” will be visible in the viewfinder (USA cameras)
-OR- a red ”.1” will be visible in the viewfinder (non-USA cameras).
•
The LCD panel will display “1.0 FT (USA cameras) -OR- will display “.1M”
(non-USA cameras).
Summary of Contents for Spectra/Image One Board
