29
TRANSMITTER/RECEIVER
NOTE: All Polaris Automatic Gate Operator transmitters use a
standard code set at the factory. It is recommended that this
code is re-set for safety and security before programming
receiver.
Step 1
Remove the battery access cover on the transmitter.
When the cover is off, you will see the battery and the
DIP switches.
Step 2
The DIP switch block contains 10 small switches.
Using a small screwdriver or pen, move any switch or
combination of the switches to either the open or closed
position.
NOTE: Do not set the switches to all open or all closed.
Step 3
Locate the LEARN CODE button on the circuit board in
the control box.
Step 4
Press and hold the LEARN CODE button for at least three
seconds, but no more than five seconds. Upon release,
the CHARGING LED will light, the STATUS LED will stop
blinking, and an audible beep will occur verifying the
circuit board is in the learn code mode.
Step 5
Press and hold the transmitter button until the
CHARGING LED turns off, the STATUS light blinks, and
an audible beep occurs. Release the transmitter button.
The transmitter code is now set.
Step 6
Replace the battery access cover on the transmitter.
Step 7
Verify the transmitter is operational by pressing the
transmitter button. The RADIO RECEIVER LED will light and
the gate will move if the setting is correct.
If the gate does not move, repeat the process starting
with step 4.
NOTE: The control box circuit board can learn and hold
up to 10 different codes.
NOTE: To clear all codes, press and hold the LEARN
CODE button for 10 seconds. Two audible beeps verify
LEARN CODE has been cleared.
Figure 26
Figure 25
DIP switches
Transmitter
TRANSMITTER/RECEIVER
Summary of Contents for 502
Page 22: ...22 WIRING OPERATOR ...
Page 33: ...33 EXIT WAND HOOK UP DIAGRAM ...
Page 34: ...34 PHOTO EYE HOOK UP DIAGRAM ...
Page 35: ...35 PHOTO EYE HOOK UP DIAGRAM ...
