- 5 -
1300_GB-ANBAU_293
GB
ATTACHING TO TRACTOR
Hydraulic connection
The tractor must be equipped with at least a double
acting and a single acting hydraulic connection.
Connect hydraulic lines at tractor
- Connect hydraulic line to tractor only with closed stop
cock (position A).
Single action Couple the plug with the dust
cap "red" to the single acting control valve.
Double action Couple both plugs with dust cap "blue" to
the double acting control valve.
A
E
TD 26/92/16
s
h
0
ST
Initial attaching to tractor
1. Attach the drawbar on tractor tool bar.
Important!
- The tool bar must be mobile (A-B)
- The holes in the tool bar must have a diameter of at
least 30 mm.
- The left and right lifting struts (4) must be the same
length.
2. Secure the plug-in bolts with pins.
3. Fix the hydraulic lower link (5) so that the implement
cannot swivel out to the sides.
4. Swivel up the supporting leg (10) and secure it with
bolts.
5. Set the tractor hydraulic unit at the right height (H).
Pay attention to have a sufficient distance to the cardan
shaft (X), especially if you drive over ground tops!
6. Connect the tractor hydraulic lines.
- Stop cock closed (position A).
- Connect tractor hydraulic line.
7. Lower the implement
- Stop cock open (position E).
- Operate the single acting control valve (ST).
The implement lowers slowly to reach the ground.
Safety hints:
see Annex A1 pt.
(8a. - 8i.)
DW
DW
EW
TD44/94/1
