- 17 -
1400_GB-Multitast_293
GB
THE "MULTITAST" SYSTEM
Changeover for operation with feeler
wheel
1. Only fit the feeler wheel (2) on the left (direction of
travel). See included retrofitting directions - feeler wheel
243.32.001.0
415-14-02
2
4
5
2. Lower both rotor units to the ground.
3. Remove spindle from rear rotor (6)
4. Fit hydraulic cylinder to rear rotor (Hyd)
5. Correctly set the distance (X1) with the front threaded
spindle
- see chapter "Attaching to tractor"
Changeover for operation without feeler
wheel
1. Remove axle (1)
2. Remove axle beam:
- Remove hydraulic hose holder (2)
- Remove groove nut (3)
2
1
3
3. Swing the axle beam 180° to the rear and refit.
4. Swing the axle 180° to the rear and refit (pos. 4)
5. Set up both rotor units as parallel as possible on even
ground.
415-14-03
4
5
6. Remove the hydraulic cylinder from the rear rotor and
fit the spindle for the changeover set (6).
- Set the spindle (6) so that the position of the rotor
tines is as parallel to the ground as possible (A1).
Operating machine without feeler wheel
Particular operating conditions can require the feeler wheel
(2) to be removed.
• If working without feeler wheel (2) then the rotor unit
pivoting joint must be fixed. Otherwise the rotor unit
will tip down and dig the tines into the ground.
However ground adaptation with a fixed pivoting joint is no
longer optimal. Therefore this operating mode should be
avoided whenever possible.
7. Correctly set the distance (X1) with the front threaded
spindle
- see chapter "Attaching to tractor"
8. Remove feeler wheel (2)
