- 7 -
1300_GB-ANBAU_293
GB
ATTACHING TO TRACTOR
Setting the sequential valve
The sequential valve regulates the logical sequence in which rotors are lifted hydraulically.
You set the sequence by rotating the adjusting screw pos. 8 on the threaded bar pos. 3.
1. Observe the general safety information.
2. Couple machine to tractor.
3. Bring machine in working position.
4. Lift rotor.
Shortly before complete lifting of the first rotor (direction of driving!), the second rotor should be lifted.
5. If the second rotor is lifted too early, correct the setting on the threaded bar.
6. Repeat the procedure until the setting is correct.
Hydraulic hoses and electrical cables
Note: Hydraulic hoses and electrical cables are mounted
overhanging on the machine. The machine can be thus
attached to various tractors.
• Roll hydraulic lines and electrical cables together
accordingly and fasten them with cable tie (K).
• Hydraulic hoses and electrical cables may
not be damages by the rotating rotors.
There must be sufficient distance to the
rotating parts, also when cornering.
• Observe lengths "L1 and L2"!
8
3
Sequential valve
