Plymovent MDB GO, Installation And User Manual

Page: 8 / 21

0000100513/050719/C MDB GO | MDB PRO 7
Fig. 4.6
Dustbin lift
• Install the dustbin lift (B) to the frame. Put the bolts
M10x40 (A) from the inside into the slotted holes
3
.
Fig. 4.6
D
A
A
B
A
B
C
A
Dustbin lift
Fig. 4.7
• Install the locking device (A) with 2 washers and 2 bolts.
Fig. 4.7
D
A
A
B
A
B
C
A
Locking device
Fig. 4.8
• Put the lifting pin (B) through the holes and attach it with 2
cotter pins (A).
• Put the extension pin with handle (C) into the lifting pin.
Fig. 4.8
D
A
A
B
A
B
C
A
Lifting pin
Fig. 4.9
Sealing (MDB seal assembly set)
How to apply the seals: How to use SealApplicator:
• Remove dust, if any, from the upper frame.
• Lay the seals loosely on the frame and put them together
4
.
• Make sure that the jigsaws tightly fit.
3. No nuts involved. The dustbin lift has some tolerance
4. Do not worry about a slight misalignment of the seal holes
Fig. 4.9 Seals on frame
One strip 846 mm (33.3 in.) is redundant.
Fig. 4.10
• Start with a long seal (1046 mm).
• Try to avoid touching the sticky side with your
fingers.
• Make sure that you attach the seal in the centre
of the frame edges and that the jigsaws fit
together.
• Peel approx. 50 mm of the backing material (A) and stick
the seal on the frame. Draw the backing material to the
inside of the frame.
• Continue to peel and stick the seal in steps of approx. 50
mm according to the indicated sequence (B).
Fig. 4.10
A
B
± 50 mm
1
2
3
4
5
Removal of backing material
4.4 Filter modules (MDB-BM/2 and/or
MDB-BM/4)
MDB filter systems often consist of more than one filter
module. You must assemble the system layer by layer from
left to right.
Fig. IV on page 18 shows an example of the
correct sequence.
If applicable: install the MDB-BM/2 module(s) first.
Specially constructed seals (MDB seal assembly set) between
the frame, the individual filter modules, the air inlet/outlet
modules and the cover plates are necessary to make the entire
MDB system airtight. The top and right side of each filter
module are already provided with seals. Only the filter
modules on the left side of the MDB system must be provided
with additional seals. The number depends on the system
configuration.