Plymovent MDB GO, Installation And User Manual

Page: 7 / 21

0000100513/050719/C MDB GO | MDB PRO 6
4.3 Mounting frame (MDB-FRAME)
Fig. 4.1
• Assemble the mounting frame
2
with the bolts M8x16 (A)
and washers (B). Tighten the bolts loosely .
Fig. 4.1
B
A
C
A
B
D
Assembly of the mounting frame
4.3.1 Air outlet module (option) or cover plate and
hopper
It is possible to install an air outlet module (MDB-OUTLET)
behind the hopper (MDB-HOPPER). If you do not, you must
install a cover plate (MDB-COVER/U) at that position. Refer to
Fig. III on page 18.
To install an air outlet module, do the following.
To know all possible positions of the air outlet
module, refer to Fig. V on page 18 (B).
Air outlet module (MDB-OUTLET)
Fig. 4.4
• Drill a Ø 9 mm (0.25 in.) hole in the two notches (A) of the
outlet module.
Fig. 4.2
A (2x)
Air outlet module
2. Note: the “open” sides of the bars are on the outside
Fig. 4.3
• Temporary disassemble the back side of the frame to put
the outlet module on the frame.
Fig. 4.3 Air outlet module on frame
Fig. 4.4
• Slightly lift the outlet module and put the support profiles
(A) in the slits (B).
Fig. 4.4
A (2x)
B (4x)
Support profiles
Fig. 4.5
Hopper (MDB-HOPPER)
• Put the hopper (B) on the frame.
Cover plate (MDB-COVER/U)
If you have not installed an air outlet module (MDB-OUTLET),
you must install a cover plate (MDB-COVER/U).
• If applicable: put the cover plate (A) on the frame.
Fig. 4.5
A
B
A
B
cover plate
Fastening
• Tighten the bolts of the entire frame (refer to Fig. 4.1).