Plymovent MDB GO, Installation And User Manual

Page: 12 / 21

0000100513/050719/C MDB GO | MDB PRO 11
Fig. 4.24
• Install the deflector plates (A) inside the filter module at
the position of the air inlet module (top or side) with the
flange screws (B).
• Make sure to align the deflector plates with the holes in the
filter module (C).
Fig. 4.24
B (4x)
A (2x)
C
Deflector plates
4.5.2 Air inlet module
To install the air inlet module, do the following.
Fig. 4.25
• Make additional holes in the seals on the filter module, at
the position where you want to install the air inlet module.
• (1) Remove the backing material of the seals.
• (2) Spray SealApplicator lubricant on the seals.
• Put the air inlet module (A)
within 60 seconds on the
filter module.
• (3) Attach the air inlet module with the flange screws.
If applicable:
• Repeat this procedure for the other air inlet module(s).
• Apply duct tape to interconnect two or more air inlet
modules. Make sure that the connection is airtight.
Fig. 4.25
SOORTELIJKE TEKENNG
MET DEFLECTION PLATES
LOSSE BOORSCHROEVEN/
DRILL SCREWS
20x
20x
A
11
2
3
4
Air inlet/outlet module(s)
4.5.3 Air outlet module
Refer to section 4.5.2. Air inlet module = air outlet module.
4.5.4 End cap
Each air inlet and outlet module comes with an end cap. When
you install ducting at both sides of the modules, you do not
need to install an end cap.
If applicable:
• Put an end cap on the open side of the air inlet/outlet
module.
• Fasten it with self-tapping screws.
• Use duct tape to make the connection airtight.
4.6 Compressed air connection
Each filter module contains one pressure hose with
a sT-connector.
Fig. 4.26
• Put each T-connector (C) in the back of each filter module.
• Connect the hoses in series.
• Put an end plug (A) in the last T-connector.
• Install a compressed air regulator (CAR-KIT or similar) (B)
on the mounting frame. Set it to 5 bar.
• Connect the loose end of the pressure hose to the
compressed air regulator. Make sure that the airflow
direction through the regulator is correct; this is indicated
by the arrow on the back side.
• Connect the compressed air regulator to the compressed
air supply.
Fig. 4.26
+
+
SCP-MDB
+
A
C
+
+
SCP-MDB
A
D
E
C
B
+
G
F
H
B
Pressure hose
4.7 Cover plates
Fig. 4.27
• Make additional holes in the seals. They must correspond
with the holes in the filter module.
• (1) Remove the cage nuts from the top side of the filter
module(s).
• (2) Remove the backing material of the seals.
• (3) Spray SealApplicator lubricant on the seals.
• Put one cover plate within 60 seconds on the filter module.
• (4) Attach the cover plate with the flange screws.
• Repeat this procedure for the remaining cover plates.