Plymovent MDB GO, Installation And User Manual

Page: 13 / 21

0000100513/050719/C MDB GO | MDB PRO 12
Fig. 4.27
2
1
3
4
Cover plates
4.8 Filter cartridges
To install the filter cartridges, do the following.
Fig. 4.28
• Loosen the star knob (F) and disassemble the cover plate
(E), the nut (D) and the metal washer (C).
• Put the filter cartridge (B) on the cartridge holder (A).
• Install the removed parts in reverse order.
Fig. 4.28
A B
D C E F
Installation of the filter cartridges
ATTENTION
Make sure that the front of the filter cartridge
aligns
*)
with the filter housing, so that the lid closes
well. If this is not the case, the filter cartridge is not
positioned correctly. This can cause leakage and less
efficient operation of the filter cartridge.
*)
tolerance: max. 2 mm (0.1 in.)
>2 mm
max. 2 mm
>2 mm
max. 2 mm
>2 mm
max. 2 mm
>2 mm
max. 2 mm
• Do the same procedure for the remaining filter
cartridge(s).
4.9 Dustbin
Fig. 4.29
• Put the dustbin (D) below the hopper (A).
• Use the handle (C) to lift the dustbin and put it in the right
position.
• Attach the dustbin to the hopper with the quick connect
clamp (B).
Fig. 4.29
A
B
C
D
Dustbin
4.10 Electric connection
For the electric connection of the filter cleaning
system and the fan, refer to the installation manual
of the control equipment ControlGo or ControlPro,
that is supplied with the product.
4.11 Options
4.11.1 Balancing damper MRD-315/400/500
• Install the damper at an appropriate position in the inlet
duct.
4.11.2 PRECO-N (precoat material)
Personal protective equipment (PPE)
Wear respiratory protection and protective
gloves when you apply precoat material.
• Disconnect the compressed air supply.
• Put the precoat material in a bucket.
• Remove the dustbin.
• Start the connected fan. It must run at full speed.
• Gradually
11
add the precoat material into the hopper.
• Stop the fan.
• Install the dustbin.
4.12 Installation checklist
√
√
√
# Check OK
1. Have you tightened all bolts of the mounting frame?
2. Are all connections airtight?
3. Is 4-5 bar of compressed air available?
4. Are the filter cartridges installed in the right way?
5. Is the dustbin correctly installed? Is it attached to the
hopper with the quick connect clamp?
11. Dosing speed: approx. 1 kg (2.2 lbs.) per minute