Legion Solar Installation and Operations Manual
Copyright © 2021 PLX Devices Inc.
10
Step2:
Place 2 M8 washers on the frame above the two holes. 1
washer per side.
Step3:
Place the MicroInverter on top washers and align the holes
with the 2 L shaped notches.
Step4:
Place 2 M8 washers on top of the L shaped notches. Align the
washers with the hole.
Step5:
Insert the 2 Hex Screw Thread 1.25mm M8 x 20mm long into
the hole making sure the screw goes through the washers.
Step6:
Insert the lock washer M8 followed by the Hex Nut Thread
1.25mm M8. Tighten the screws with 6mm hex key and
14mm wrench.
Step7:
Install the Antenna. If the Inverter is within 30ft of Solar
Regulator and is unobstructed by dense materials such as
metal, concrete, brick, tile you may install the Antenna
directly on the Inverter.
Otherwise, we recommend using the included SMA coax wire
(1) to locate your Antenna (2) out and above the PV panels
for improved wireless performance and reliability.
Use the included aluminum plate (3) designed to be installed
on the Legion Solar End Clamp or Mid Clamp with a 1/4-20
nut (4).