Plus N-324, User Manual, Page: 17 / 34

E-17
Printing
Press the Network Print or the On Board Print button to print.
Note
• “01” is selected when the power is turned on.
• Up to 10 copies can be specified and displayed on the display window.
• The number of copies increases by 1 each time the Number of Copies button is pressed, and “
” is displayed
after “10” (this is used for test printing: see page E-30). When the button is pressed again, the display switches to
“01”. The number switches continuously if the button is held in.
• After setting the number of copies, proceed to step 4 within 1 minute. The number of copies is reset to “01” if no
operation is performed within 1 minute.
The reading operation is performed for a one-sheet portion (while the sheet is scrolled) and the printing operation is per -
formed.
To change printing color (Color or B/W), perform thumbnail printing or continuous printing, make each setting (see next
page) and press the appropriate Print button.
Notice
• To use the network printing function, connect the FTP supported printer to the same network where the network
board is located, and make the printer settings on the network board.
Cancellation of the print operation in progress
When the ON/Standby button is pressed, the reading of the sheet stops, and the partially read image data is printed.
Wait until the sheet is expelled from the printer.
Note
• If the ON/Standby button is pressed while the sheet surface is being read, printing is interrupted and only part
of the image will be printed.
• The one-screen portion is reduced to A4 paper size and printed.
For wide type network boards (model N-32W), the image is compressed about 75% in the horizontal direction.
To print with the same proportions as the image on the sheet surface, see “CB Setup (Operating the Network
Board’s Buttons)” (page E-24).
• A flashing “ ” in the display window indicates a print error. See “Meaning of Error Messages” on Page E-27.
• When printing, a time stamp (date and time) is printed at the top right of the sheet. See “CB Setup (Operating the
Network Board’s Buttons)” on page E-24.
or
• Switch off the printer power.
Note
• When the Erase Reminder function is set to “Enable”
When the ON/Standby button is pressed, the display window and all the indicators flash simul
-
taneously, the sheet automatically moves to the surface that is not yet erased and the power turns
off. To set the Erase Reminder function to “Disable”, see page E-26.
* The Erase Reminder function may not work properly due to dirt on the sheet's adhesive sections
or marker residue.
• If no button is operated within 30 minutes, the power turns off automatically (auto power off).
When the power is turned off, scanned images stored in the unit’s internal memory are cleared.
• The auto power off function is canceled when the network board and computer are connected by USB cable.
When the network board is not going to be used, press the ON/Standby button and
switch off the power (standby mode).