16
7.8.
Replacing Motor (AR-260 and AR-350)
Replace the Motor if it is broken.
1.
Remove the Ceiling Hoist from the rail and place it where you can safely carry out repairs.
2.
Remove both covers.
3.
Disconnect the wiring from the Motor.
4.
Remove the three bolts (2) that mount the Motor (
Hex 4
).
5.
Remove the Motor from the Ceiling Hoist.
6.
Install the assembly plate (3) of the broken Motor on the new Motor with the three bolts (2) (
Hex 4
).
7.
Lubricate the axle (Kroon Oil Lithep Grease EP2).
8.
Place the Woodruff key (1) on the motor axle.
9.
Place the Motor (5) on the Ceiling Hoist in the upright position. Guide the wedge to make it drop in
the slot of the axle. This can be done using a wide flat screwdriver.
10.
Install the three bolts (
Hex 4
).
11.
Place the wiring with 2 tie-wraps.
Figure 17, replacing Motor
Figure 16, Motor wiring overview
Lubricate axle
Guide the
Woodruff
key
