7
3.
Overview of Parts (AR-200)
Number
Name
Function
01
Trolley
Move Ceiling Hoist along the rail.
02
Magnet (optional)
Activate the Sensors in a Turntable, Switch and Coupling.
03
Wheel cap
Cover on Bearing.
04
Strap Tension Switch
Activates the Ceiling Hoist when tension is put on Lifting Tape.
05
End Switch Lifting Tape
Turns off the Ceiling Hoist at the end of the Lifting Tape.
06
Electronic brake
Stops the Motor when not in use.
07
Lifting Tape
Lifting Tape used for lifting.
08
Motor
Rotates the Spool which winds the Lifting Tape.
09
LED Unit
Battery indicator Green = full, orange = charge, red = critical.
10
Battery 1
Battery 12 volt, 2.9 Amperes.
11
Battery 2
Battery 12 volt, 2.9 Amperes.
12
Hand Control
Operating and charging of Ceiling Hoist.
13
Emergency stop switch
Deactivates the Ceiling Hoist in case of Emergency and lowers load
14
Height limit plate
Stops the Ceiling Hoist at highest position.
15
Lifting Tape clamp
Pushes Height limit plate and stores Hand Control
16
Printed Circuit Board
Controls the Ceiling Hoist.
17
Emergency stop (Cord)
Deactivates the Ceiling Hoist in case of Emergency and lowers load
18
Lifting Tape connector
Attachment point for an electronic or mechanical Spreader Bar.
Figure 2, Overview AR-200