14
7.6.
Replacing Lifting Tape (AR-260 and AR-350)
Replace the Lifting Tape in case of any kind of wear.
1.
Remove the Ceiling Hoist from the rail and place it where you
can safely carry out repairs.
2.
Remove both covers (
chapter 7.1
).
3.
Connect the Hand Control to the Ceiling Hoist.
4.
Fully unwind the Lifting Tape using the Hand Control. Keep
manual tension on the Lifting Tape. The bolt which attaches
the Lifting Tape (step 6) is located behind Battery 1. Turn the
Spool until the head of the bolt with the ‘BOLT STRAP’
label is visible through the ‘BOLT STRAP’ hole.
5.
Turn off the Ceiling Hoist. You can do this by using the
Emergency stop cord.
6.
Disconnect the wiring from Battery 1.
7.
Remove the screw (Hex 4).
8.
Pull the Lifting Tape from the Ceiling
Hoist.
9.
Remove the Central Suspension Point
of the old Lifting Tape.
10.
Push the new Lifting Tape through the
opening and guide it to the roll axle
through the Battery space as shown in
Figure 12 (red line).
11.
Push the loop through the bolt recess
and apply
Loctite 243
(
Figure 11
) on the wire of
the bolt, push it through the loop and
tighten it.
12.
Replace the Central Suspension Point
on the Lifting Tape as shown in with
Loctite 243
.
13.
Replace the Battery and connect it (
chapter 7.2
).
14.
Check the operation by winding and unwinding the Lifting
Tape.
15.
Test the new Lifting Tape with a load.
16.
If working properly; Place the covers (
chapter 7.1
).
Note!
Use the same bolt for the Lifting Tape because it
is an extra strong bolt (12.9), special for that function.
Place the old Central Suspension Point on the new
Lifting Tape. Use
Loctite 243
to fix the bolt in place in
the Central Suspension Point.
Inspection:
Ensure that the Lifting Tape moves along 2
roles and the axle of the Lifting Tape stop. The Ceiling
Hoist will not work if the Lifting Tape does not move
along the Lifting Tape tension axle.
Figure 11, bolt mount Lifting Tape
Figure 12, Lifting Tape guide
Figure 13, Assemble of CSP and Lifting Tape Block
Loctite 243
Loctite 243