Section 2. Installing the PX-820A Internal ATAPI Drive
30
PX-820 Installation and Users Manual
Figure 15: Connect one end of the IDE cable to the motherboard and
the other end to the drive. If your Plextor drive is the only device on
the cable, attach it at the end of the cable, leaving the
center connector free.
CAUTION
: With some IDE ribbon cables, it is easy to accidentally
plug your IDE cable upside down into both your drive and the
motherboard. Be sure you match the red stripe along one side of the
IDE cable to Pin 1 on the motherboard and Pin 1 on the drive. (Pin 1
on the drive is closest to the power connector.) Note that each
connector on most ribbon cables also has a “key” in the middle. This
key should fit into a slot in the middle of each connector of the
motherboard, your PX-820A drive, and any other internal IDE
peripherals.
8.
Double-check your work. You must ensure the side of the IDE cable
with the red stripe is matched to Pin 1 on the interface board and on
the drive.
CAUTION
: In the case of only one IDE device, you must make
certain that one end of the cable is always connected to the IDE
connector on the motherboard. The other end of the connector must
be connected to a device. The end connector of the cable should
never be left unconnected.
9.
Connect a power cable from the computer to the power connector
(DC INPUT) of the drive. In most computers, you will find free
power connectors that are ready for your use.
CAUTION
: The power connector on the cable and the receptacle on
the drive are keyed. Do not force the power connector into the drive,
or the drive and/or the computer may be damaged.