Section 2. Installing the PX-820A Internal ATAPI Drive
PX-820 Installation and Users Manual
29
Figure 14: Installing mounting rails (if needed)
6.
Plug one connector of the 80-conductor IDE/ATA cable into the IDE
connector on the rear panel of the drive before you insert the drive
into your computer. Then thread the cable through the front of the
open bay and back toward the motherboard. The drive should slide
smoothly into the bay. If it does not, check for obstructions in the
bay and ensure the side rails are attached properly.
7.
If not already connected, attach the other end of the IDE ribbon cable
to the connector on the motherboard.
