Section 1. Getting Started
6
PlexWriter 52/24/52A Installation and Users Manual
Rear Panel
Figure 2: Rear Panel of the PlexWriter 52/24/52A Drive
•
Digital audio output connector
: Outputs digital stereo signal. For connecting to
a sound board that supports Sony/Philips digital interface (SPDIF) or Digital-In.
•
Analog audio output connector
: Outputs an analog stereo signal for connecting
to a sound board or audio amplifier. Use a standard MPC-3 type, 4-pin connector.
•
DMA jumper
: Use the DMA jumper to convert between Ultra DMA Mode 0-2
(no jumper, default) and Multiword DMA Mode 0-2 (with jumper installed). In
general, leave this jumper at its factory setting, which is Ultra DMA (that is, no
jumper installed).
•
Mode jumper
: Use the mode jumper to select operation as an IDE master or
slave, or for cable select. In general, leave this jumper at its factory setting, which
is master.
•
IDE cable connector
: Connects to IDE (ATAPI) interface using 40-pin IDE flat
ribbon cable.
•
Power connector
: Connects to your computer’s power supply to provide
DC +5 volts and +12 volts to the PlexWriter.
