
42 Configuring the iPORT SB-Pro IP Engine
Copyright © 2011 Pleora Technologies Inc.
System Requirements
You require the following components to set up a multi-cast network configuration:
•
Sony
®
Block FCB-H11 Camera with iPORT SB-Pro IP engine
•
vDisplay HDMI-Pro
•
Compatible display monitor
•
Cable to connect the vDisplay IP engine to the display monitor
•
Cat5e or Cat6 Ethernet cables (3)
•
GigE Switch (IGMP v2-compatible)
•
PC or Laptop with the eBUS SDK version 2.0.0 (or higher) installed
Connecting the Hardware and Power
The procedure below explains how to connect the power, network, and data cables to the vDisplay
HDMI-Pro and iPORT SB-Pro IP engines.
To set up the configuration, perform an un-powered connection of the hardware components:
1. Connect one end of a Cat5/Cat6 cable into the RJ-45 jack of the vDisplay HDMI-Pro IP engine;
attach the other end to an available port of the GigE Switch.
2. Connect one end of a Cat5/Cat6 cable into the RJ-45 jack of the iPORT SB-Pro IP engine; attach
the other end to an available port of the GigE Switch.
3. Attach one end of video cable to the display monitor; attach the other end to the HDMI receptacle
of the vDisplay HDMI-Pro IP engine.
4. Apply power to the vDisplay HDMI-Pro IP engine.
The message, “No Video” appears on the display monitor.
5. Apply power to the iPORT SB-Pro IP engine.
IP Engine Configuration
After you have connected and powered up the hardware components, you must configure the vDisplay
HDMI-Pro and iPORT SB-Pro IP engines for multicast configuration using the GEVPlayer application.
It is preferable to launch 2 copies of GEVPlayer to perform both configurations. Configure the vDisplay
IP engine first.
Configuring the vDisplay IP Engine
1. Start the
GEVPlayer
application.
2. In the section,
“Unicast Network Configuration” on page 39
, follow Steps 2 to 6 to connect to the
vDisplay HDMI-Pro IP engine. Choose to connect as a controller (the value chosen in the Stream
Destination group is unimportant).
No Video
Summary of Contents for iPort SB-Pro
