Pleora Technologies iPort SB-Pro, User Manual, Page: 23 / 55

23
Copyright © 2011 Pleora Technologies Inc.
Connecting the iPORT SB-Pro IP Engine to the FCB-H11
The procedure below explains the assembly of the iPORT SB-Pro IP engine to the Sony Block FCB-
H11 camera.
NOTE! Do not connect power to the iPORT SB-Pro IP engine until all cable connections are secure
and verified.
Connecting the Hardware to Power/GPIO Connector
Power to the assembled Sony Block and iPORT SB-Pro IP engine is provided though the 12-Pin Hirose
circular connector as shown in the figure below.
NOTE! A chassis is supplied only as part of the iPORT SB-Pro IP engine
development
kit.
1. Connect the 20-Pin FFC cable at J5 of the IP engine’s daughter card to the GPIO connector adapter
board. The metallic side of the cable ends should be oriented towards the circuit board in both
cases.
2. Connect the 24-Pin FFC from the connector on the side of the Sony Block to the daughter card at J7
Lift up gently on the daughter card connector before inserting the cable. Push down on the
connector to secure the cable. The metallic side of the cable ends should be oriented towards the
FCB-H11 circuit board, and away from the Ethernet connector of the iPORT SB-Pro IP engine .
24-Pin FFC
NOTE: The blue band of the ribbon
cable mates to the brown hinge of
the connector on the FCB -H11