7077-801D • September 17, 2019
(877) 477- 4768
16
• Frequency:
Monthly or every 25 bags or more
frequently depending on ash build-up.
• By:
Homeowner
a. Appliance must be completely cool.
b. Open the door and remove the center baffle first
and then the right and left baffles. Thoroughly
vacuum the exhaust path and drop tube and
continue throughout the rest of the firebox. Also
vacuum the front and back of the baffles.
c. Using a small brush, clean the inner walls of the
exhaust outlet from the access hole inside the
firebox. The access hole will be visible following the
removal of the left side baffle. After loosening up
debris on the inner walls of the outlet, vacuum out.
–
This is important as the exhaust temperature
probe is attached to the right side of the outlet.
If this is not maintained on a regular basis, the
appliance will experience nuisance shut downs
and/or missed ignitions.
d. Replace the right and left baffles and then the
center baffle and close and latch the door.
• Frequency:
Monthly or prior to heating season
• By:
Homeowner
The gasket between the glass and firebox should be
inspected periodically to make sure there is a good seal.
NOTE:
GHP recommends using a heavy duty vacuum
cleaner specifically designed for solid fuel
appliance cleaning.
1
2
3
• Frequency:
Monthly depending on Dust/Dirt build-up
• By:
Homeowner or Qualified Service Technician
a. Be sure the appliance is allowed to cool and has
been unplugged.
b. Remove the right side panel.
c. Sweep or vacuum out any build-up on the
impellers. Use a brush or compressed air to loosen
dirt if needed.
–
Avoid damaging the impellers.
• Frequency:
Yearly or more frequently depending on
ash build-up
• By:
Homeowner or Qualified Service Technician
a. Be sure the appliance is allowed to cool, has been
unplugged and the exhaust blower is off.
b. Remove the left side panel.
c. Remove the six screws holding the exhaust blower
motor to the housing and remove the motor.
Using caution as to not damage the gasket when
removing the blower. If damage occurs, install a
new gasket available as a replacement part.
d. Vacuum the blower’s impellers. Use care not to
bend or damage the blower fins.
e. Using a brush or vacuum attachment, clean the
inside of the exhaust outlet.
f. Reattach the motor. Make sure the wires are
attached to the terminals on the blower.
7.
Cleaning the Exhaust Path, Baffles & Drop Tube
8. Door Handle Inspection
9. Cleaning Convection Blower - Requires No
Lubrication
10. Cleaning Exhaust Blower - Requires No
Lubrication
